According to the damage status of each connecting equipment in recent years, its professional operators also summed up a truth, that is, the equipment that is easy to damage has not been more professional maintenance basically, because long-term application will certainly affect the good applicability of a device, therefore, it is necessary for each application business to learn the most professional maintenance methods, which is the introduction to this aspect This is the case with its pipe repairer equipment, so today we will learn about it together.
The instructions for the use of the pipe connector are mainly divided into four steps. Now, to be brief, if you don’t understand, you can contact us directly.
The first step is to confirm the outer diameter of the pipe and select the corresponding type of connector. Don’t choose wrong
The second step is to remove the burrs, sharp corners and sundries at the pipe end, so as to ensure that there are no foreign matters under the sealing rubber ring and on the steel pipe.
Third, mark the ends of the two pipes to make the connector in the middle position. After inserting the product into one pipe, align the two pipe ends, and then move the connector to the middle of the two pipes.
The fourth step is to adjust the connector, and then use the Allen wrench to tighten the bolt more than DN150 evenly. After tightening the bolt, use the mallet to knock around the inside of both sides of the connector to make the gap with the pipe even, and then tighten the bolt again to achieve the best sealing effect.
With regard to the poor application performance of pipeline quick connector, the head will have various damage status quo, followed by the non improvement of operation rate. Therefore, for the relevant introduction we give you above, we must pay attention to and pay attention to each operation operator.
Post time: Jun-17-2020